壓住材料?？朔鹘y(tǒng)的模具設計結構，在卸料板上開出容料間隙(即模具閉合時，卸料板與凹模貼合，而容納材料處卸料板與凹模的間隙為材料厚t-0.03～0.05mm)。如此，沖壓中卸料板運動平穩，而材料又可被壓緊。關鍵成形部位，卸料板一定做成鑲塊式結構，以方便解決長時間沖壓所導致卸料板壓料部位產生的磨(壓)損，而無法壓緊材料。

Press the material. In order to overcome the traditional mold design structure, the clearance of material is opened on the discharge plate (i.e., when the die is closed, the discharge plate and the die are fitted, and the gap between the discharge plate and the die is t-0.03 to 0.05mm). In this way, the discharging plate moves smoothly, and the material can be pressed tightly. In the key forming part, the discharge plate must be made into an inlaid structure to facilitate the solution of the grinding (pressure) loss caused by the pressing part of the unloading plate for a long time, and the material can not be pressed.

日常模具生產中，應注意維護沖切凸、凹模刃口的鋒利度。當沖切刃口磨損時，材料所受拉應力將增大，從而沖壓件產生翻料、扭曲的趨向加大。

In daily mold production, attention should be paid to sharpness of punching and concave die edges. When the cutting edge is worn, the tensile stress of the material will increase, and the stamping and bending will increase.

槽鋼的鋸削：槽鋼的鋸削與扁鋼一樣，但是要分二次從寬邊面往下鋸，不能在一個面上往下鋸，應盡量做到在長的鋸縫口上起鋸，因此工件必須多次改變夾持的位置。

Channel steel sawing: the channel sawing of the channel steel is the same as that of the flat steel, but it must be sawed down two times from the wide side, and can not be sawed down on one surface, and should be sawed on the long saw mouth as far as  so the  of the clamping must be changed many times.