合理的模具設計。在級進模中,下料順序的安排有可能影響到?jīng)_壓件成形的精度。針對沖壓件細小部位的下料，一般先安排較大面積之沖切下料，再安排較小面積的沖切下料，以減輕沖裁力對沖壓件成形的影響。

Reasonable mold design. In progressive die, the order of blanking sequence may affect the accuracy of stamping forming. In order to reduce the impact of punching parts, the punching and cutting blanking of small area is arranged in the light of the blanking of the small parts of the stamping parts.

設計的沖壓件必須形狀簡單，結構合理，以有利于簡化模具結構、簡化工序數量，即用少、簡單的沖壓工序完成整個零件的加工，減少再用其他方法加工，并有利于沖壓操作，便于組織實現機械化與自動化生產，以高勞動生產率。

設計的沖壓件，在保證能正常使用情況下，盡量使尺寸精度等級及表面粗糙度等級要求低一些，并有利于產品的互換，減少廢品、保證產品質量穩定。

設計的沖壓件，應有利于盡可能使用現有設備、工藝裝備以及工藝流程對其進行加工，并有利于沖模使用壽命的延長。

手鋸鋸削的注意事項

鋸條的松緊要合適，且鋸割時壓力不能太大，以防折斷傷人；

當鋸縫歪斜時，不可急于糾正，而需要慢慢地逐步糾正。

Notice of hand saw cutting

The tightness of the saw blade should be suitable, and the pressure should not be too large during sawing, so as to prevent breaking and hurting people.

When the SAW seam is skewed, it can not be corrected in a hurry, but it needs to be corrected gradually.