特別是輸出輥道，過去多采用上述方法對中，但是近有把輥距縮小的傾向，因而采用后一種斜輥布置方式的輥道正在減少。這是為了在軋制薄規(guī)格的帶鋼時避免使帶鋼在輥道上因終軋速度高而造成折疊。此外，對于輥道的速度和輥子直徑也要充分考慮好。

In particular, the output roller table used to use the above methods in the past, but recently there is a tendency to narrow the distance between rolls. Therefore, the roller table with the latter one is decreasing. to avoid folding the strip on a thin strip of strip to avoid the high finishing speed of the strip on the roller. In addition, the speed of the roller and the diameter of the roller should be fully cidered.

鏈板輸送機以標(biāo)準(zhǔn)鏈板為承載面，由馬達(dá)減速機為動力傳動；我們可以通過多列鏈板并行，使鏈板輸送機做的很寬并形成差速，利用多列鏈板的速度差使多列輸送在無擠壓的情況下變?yōu)閱瘟休斔汀?/span>

The chain plate conveyer takes the standard chain plate as the bearing surface, and the motor reducer is driven by the motor. We can make the chain conveyor be very wide and form the differential speed through the multi chain chain plate.