在運轉200~300小時后，應進行換油，在以后的使用中應定期檢查油的質量，對于混入雜質或變質的油須及時更換。一般情況下，對于長期連續工作的減速機，按運行5000小時或每年一次更換新油.

After running for 200~300 hours, the first oil change should be done. The quality of the oil should be checked regularly in later use, and the oil mixed with impurities or deterioration must be changed in time. In general, for a long-term continuous working reducer, new oil is replaced at 5000 hours or once a year.

安裝前，將電機輸入軸、定位凸臺及減速機連接部位的防銹油用或鋅鈉水擦拭凈。其目的是保證連接的緊密性及運轉的靈活性，并且防止不必要的磨損。

Before installation, the anti rust oil of the motor input shaft, the itioning protruding platform and the connecting part of the reducer is cleaned with gasoline or zinc sodium water. The pure is to ensure the tightness of the connection and the flexibility of the operation, and to prevent unnecessary wear.

減速機與工作機的安裝關系：為了避免工作機主軸撓曲及在減速機軸承上產生附加力，減速機與工作機之間的距離，在不影響正常的工作的條件下應盡量小，其值為5-10mm。

The relatihip between the reducer and the working machine is: to avoid the additional force of the spindle and the additional bearing on the reducer bearing, the distance between the reducer and the working machine should be as small as sible without affecting the normal working conditi, and its value is 5-10mm.