整個軋鋼生產過程總是有以下幾個基本工序組成的：

坯料準備，包括表面缺陷的清理，表面氧化鐵皮的去除和坯料的預先熱處理等。坯料的加熱，是熱軋生產工藝過程的重要工序。

The whole rolling process of steel rolling is always composed of the following basic processes:

Preparation of the billet, including the cleaning of surface defects, the removal of the iron oxide skin on the surface, and the pre heat treatment of the blank. The heating of the billet is an important process in the process of hot rolling.

軋制速度控制：即軋制時對各道次軋輥的線速度以及每道中不同階段的軋輥的速 度的具體規定，也叫速度規程。

Rolling speed : that is to say, the speed regulation is also specified for the speed of each roller and the speed of each roller  different stages in rolling.

軋輥的彈性壓扁沿輥身長度散布是不勻稱的，若邊部延伸率大。軋機支持輥的外貌肖氏硬度1樣平常為HS45左右，在另1側設專人觀察，也會出現相反的環境，薄鋼板通常以卷板和剪切成肯定長度和寬度的單張板投放市場。

The elastic flattening of the roll is uneven along the length of the roller body, and the elongation at the side is large. The appearance of the rolling mill support roll is about 1 HS45, which is normally observed on the other 1 sides, and the  environment will occur. Thin plates are usually put on the market with rolled plates and a single sheet that is cut to a certain length and width.

橫軋成型的特點是：1.兩個工作軋輥軸線平行，其轉動方向相同； 2.軋件軸線與軋輥軸線平行，軋件作轉動，其轉動方向與軋輥相反，進出料需專門裝置。

The characteristics of the cross rolling are as follows: 1. the axis of the two working rolls is parallel and its rotation direction is the same; the axis of the 2. piece is parallel to the axis of the roll, and the rolling piece is rotated. The direction of the roll is to the roll, and the special device for entering and leaving the material is needed.