通過鍛造能消除金屬在冶煉過程中產生的鑄態疏松等缺陷，優化微觀組織結構，同時由于保存了完整的金屬流線，鍛件的機械性能一般優于同樣材料的鑄件。

Forging can eliminate the defects such as casting porosity and so on during the smelting process, and optimize the microstructure. At the same time, because of the intact metal flow line, the mechanical properties of the forgings are generally better than those of the same materials.

在考慮鍛造工藝時特別是后一火的鍛造時，應盡量避免在臨界變形程度下進行，以免得到粗大晶粒組織。具體來說，高溫下金屬塑性好，變形抗力小，應采用遠大于臨界變形程度的較大變形量鍛造；低溫修正時采用低于臨界變形程度的小變形量進行局部修整。

When the forging process is cidered, especially when the last fire is forged, the critical deformation should be avoided as far as , so as to avoid coarse grain structure. Concretely speaking, high temperature metal has good plasticity and small deformation resistance. We should adopt large deformation amount forging far greater than critical deformation degree. When low temperature correction is used, small deformation below critical deformation degree should be used for local trimming.

由于熱變形形成纖維組織，會使金屬的力學性能出現異向性，即縱向力學性能指標中的A，Z，Ak比橫向相應的指標大得多，兩個方向上的強度Rm。Re差別不大。

Due to the formation of fibrous microstructure by thermal deformation, the mechanical properties of metals will be different. That is, A, Z and Ak in longitudinal mechanical properties are much larger than those itransverse direction, and the strength in two directi is Rm. Re is not very different.

定期對設備進行保養，所有的操作者工作之前必須帶好防護用具。在進行鍛造作業時，幾個操作者之間要集中精力，互相配合，躲開危險方向，選擇相對安全的位置。

Maintenance of equipment on a regular basis, and all operators must take protective equipment before working. In the process of forging, several operators should their energy, cooperate with each other, avoid the dangerous direction, and choose a relatively safe.