合理的模具設計。在級進模中,下料順序的安排有可能影響到?jīng)_壓件成形的精度。針對沖壓件細小部位的下料，一般先安排較大面積之沖切下料，再安排較小面積的沖切下料，以減輕沖裁力對沖壓件成形的影響。

Reasonable mold design. In progressive die, the order of blanking sequence may affect the accuracy of stamping forming. In order to reduce the impact of punching parts, the punching and cutting blanking of small area is arranged in the light of the blanking of the small parts of the stamping parts.

設計的沖壓件必須形狀簡單，結構合理，以有利于簡化模具結構、簡化工序數量，即用少、簡單的沖壓工序完成整個零件的加工，減少再用其他方法加工，并有利于沖壓操作，便于組織實現機械化與自動化生產，以高勞動生產率。

設計的沖壓件，在保證能正常使用情況下，盡量使尺寸精度等級及表面粗糙度等級要求低一些，并有利于產品的互換，減少廢品、保證產品質量穩定。

設計的沖壓件，應有利于盡可能使用現有設備、工藝裝備以及工藝流程對其進行加工，并有利于沖模使用壽命的延長。

增設強壓功能。即對卸料鑲塊壓料部加厚尺寸(正常的卸料鑲塊厚H 0.03mm)，以增加對凹模側材料的壓力，從而抑制沖切時沖壓件產生翻料、扭曲變形。

Additional pressure function. In order to increase the pressure on the material of the die side, the pressure of the material in the die side is increased by the thickness of the material of the unloaded insert (normal unloaded insert thickness H 0.03mm), so as to suppress the turning and distortion of the stamping parts.

深縫：鋸削深縫時即當鋸縫的深度超過鋸弓高度時，高度時，鋸弓就會與工具相碰，無法繼續鋸削；此時應將鋸條拆出，將鋸條轉90。

Deep seam: when sawing deep seams, when the depth of the sawblade exceeds the height of the saw bow, when the height is high, the saw bow is touched by the tool and can not continue to be sawed; the saw strip should be removed and the saw blade is turned 90.