增設強壓功能。即對卸料鑲塊壓料部加厚尺寸(正常的卸料鑲塊厚H 0.03mm)，以增加對凹模側材料的壓力，從而抑制沖切時沖壓件產生翻料、扭曲變形。凸模刃口端部修出斜面或弧形。這是減緩沖裁力的有效方法。減緩沖裁力，即可減輕對凹模側材料的拉伸力，從而達到抑制沖壓件產生翻料、扭曲的效果。

日常模具生產中，應注意維護沖切凸、凹模刃口的鋒利度。當沖切刃口磨損時，材料所受拉應力將增大，從而沖壓件產生翻料、扭曲的趨向加大。

壓住材料。克服傳統的模具設計結構，在卸料板上開出容料間隙(即模具閉合時，卸料板與凹模貼合，而容納材料處卸料板與凹模的間隙為材料厚t-0.03～0.05mm)。如此，沖壓中卸料板運動平穩，而材料又可被壓緊。關鍵成形部位，卸料板一定做成鑲塊式結構，以方便解決長時間沖壓所導致卸料板壓料部位產生的磨(壓)損，而無法壓緊材料。

Press the material. In order to overcome the traditional mold design structure, the clearance of material is opened on the discharge plate (i.e., when the die is closed, the discharge plate and the die are fitted, and the gap between the discharge plate and the die is t-0.03 to 0.05mm). In this way, the discharging plate moves smoothly, and the material can be pressed tightly. In the key forming part, the discharge plate must be made into an inlaid structure to facilitate the solution of the grinding (pressure) loss caused by the pressing part of the unloading plate for a long time, and the material can not be pressed.

手鋸鋸削的注意事項

鋸條的松緊要合適，且鋸割時壓力不能太大，以防折斷傷人；

當鋸縫歪斜時，不可急于糾正，而需要慢慢地逐步糾正。

Notice of hand saw cutting

The tightness of the saw blade should be suitable, and the pressure should not be too large during sawing, so as to prevent breaking and hurting people.

When the SAW seam is skewed, it can not be corrected in a hurry, but it needs to be corrected gradually.