彎曲度：工字鋼高度小于或等于400MM時，每米彎曲度不得大于1.5MM，總彎曲度不得大于總長度的0.15%。高度大于400MM時，每米彎曲度不得大于1.0MM，總彎曲度不得大于總長度的0.1%。

Bending degree: when the height of the I-steel is less than or equal to 400MM, the bending degree of each meter must not be more than 1.5MM, and the total bending degree should not be more than 0.15% of the total length. When the height is greater than 400MM, the bending degree of each meter must not be more than 1.0MM, and the total bending degree should not be more than 0.1% of the total length.

工字鋼也稱為鋼梁（英文名稱 I Beam)，是截面為工字形狀的長條鋼材。工字鋼分普通工字鋼和輕型工字鋼，H型鋼三種。工字鋼廣泛用于各種建筑結構、橋梁、車輛、支架、機械等。

I-steel beam (also known as English name I Beam), is an H-shaped steel strip section. I-steel is divided into three kinds: ordinary I-steel and light I-steel, H type steel. I-steel is widely used in various architectural structures, bridges, vehicles, stents, machinery and so on.

板材是指一般的壓型鋼板平板等,都是較薄的鋼板,通常都作為屋面或圍護墻等用型材是指熱軋的冷彎的如工字鋼H鋼C型鋼Z型鋼,通常都作主結構用。

Plate refers to the general profiled steel plate, flat plate, etc., which are thin steel plates, usually used as roofing or retaining walls.

Profiles refer to hot rolled cold-formed ones, such as I-steel, H steel, C steel and Z section steel, which are usually used for main structure.

細木工板比實木板材穩定性強，但怕潮濕，施工中應注意避免用在廚衛。

細木工板的加工工藝分機拼和手拼兩種，手工拼制是用人工將木條鑲?cè)電A板中，木條受到的擠壓力差，不能據切加工，只適宜做部分裝修的子項目，如做實木地板的墊層毛板等。

Blockboard is more stable than solid wood, but it is afraid of humidity. In ctruction, it should be avoided in kitchen and toilet.

The processing technology of the carpenter board is divided into two kinds. The manual spelling is to insert the wooden bar into the splint, the squeezing pressure of the wooden bar is poor, it can not be cut by cutting, it is only suitable for the subproject of partial decoration, such as the cushion coat of the solid wood floor.