減速機一般用于低轉速大扭矩的傳動設備，把電動機、內燃機或其它高速運轉的動力通過減速機的輸入軸上的齒數少的齒輪嚙合輸出軸上的大齒輪來達到減速的目的，普通的減速機也會有幾對相同原理齒輪達到理想的減速，大小齒輪的齒數之比，就是傳動比。

Reducer is generally used in driving equipment of low speed high torque, large gear gear output shaft power motor, internal combustion engine or other high speed running through the reducer input shaft less number of teeth on the reducer to achieve the pure of general reducer will have several pairs of the same principle to achieve the ideal effect of gear reducer. The size of the number of teeth of the gear ratio, the transmission ratio is.

安裝前，將電機輸入軸、定位凸臺及減速機連接部位的防銹油用或鋅鈉水擦拭凈。其目的是保證連接的緊密性及運轉的靈活性，并且防止不必要的磨損。

Before installation, the anti rust oil of the motor input shaft, the itioning protruding platform and the connecting part of the reducer is cleaned with gasoline or zinc sodium water. The pure is to ensure the tightness of the connection and the flexibility of the operation, and to prevent unnecessary wear.

減速機與工作機的安裝關系：為了避免工作機主軸撓曲及在減速機軸承上產生附加力，減速機與工作機之間的距離，在不影響正常的工作的條件下應盡量小，其值為5-10mm。

The relatihip between the reducer and the working machine is: to avoid the additional force of the spindle and the additional bearing on the reducer bearing, the distance between the reducer and the working machine should be as small as sible without affecting the normal working conditi, and its value is 5-10mm.

減速機性能特點

1,產品采用模塊化設計,電動機輸入,輸入軸和孔類型三個方面,并配置腳,法蘭安裝,適用于各種有效的減變速傳動,可以直接取代無級調速,擺線。  

2、能源消耗低、噪音低、振動小,減速機達96%。  

3,使用特殊的寬帶寬壓力電動機,當加載在20 hz - 60赫茲頻率范圍內正常使用。  

4、齒輪滲碳淬火熱處理工藝,采用獨特的低噪聲齒齒形設計,確保產品的使用壽命。  

Performance characteristics of reducer

1, the product adopts modular design, motor input, input shaft and hole type three aspects, and equipped with feet, flange installation, suitable for all kinds of effective variable speed transmission, which can directly replace stepless speed regulation and cycloidal.

2, the energy cumption is low, the noise is low, the vibration is small, and the efficiency of the reducer is up to 96%.

3, the use of a special wide band wide pressure motor when loaded in the range of 20 Hz - 60 Hz is normally used.

4, gear carburizing and quenching heat treatment process, using a unique low noise tooth profile design to ensure the service life of the product.