（1）堆焊前需先將軋輥輥身表面的疲勞層或缺陷，尤其是裂紋必須徹底清除；  

（2）在堆焊時，為了防止裂紋的產生，必須先加工軋輥輥身預熱，預熱溫度根據軋輥輥及堆焊材料而定。

(1) before welding, the fatigue layer or defect of the roller body surface must be first removed, especially the crack must be thoroughly removed.

(2) in the process of surfacing, in order to prevent cracks, the roller body must be pre heated, and the preheating temperature should be determined according to roll rolls and surfacing materials.

生產長材產品的軋機種類繁多，因此，軋機類型的選擇、布局，軋輥材質的選擇、軋輥尺寸的確定，選擇范圍也非常廣。同時，不同的軋機所選擇的軋輥也是不相同的，需要根據生產要求選擇軋輥。

There are a wide variety of rolling mills to produce long timber products. Therefore, the selection and layout of the type of rolling mill, the selection of the material of the roll and the determination of the size of the roll are also very wide. At the same time, the rolls chosen by  rolling mills are also the roller should be selected according to the production requirements.

當軋制其它型材時，可以用水平機架更換機架。水平機架的軋輥有很深的孔型，而機架沒有。  

較大直徑的水平軋輥確定型鋼的的形狀，而較小直徑的一對立輥用于軋制邊部。當坯料穿過傳統機架和機架精軋軋輥時，可以獲得很好的表面光潔度和尺寸公差。  

When rolling other profiles, the universal rack can be replaced with a horizontal rack. The roll of the horizontal frame has a very deep pass, but the universal rack does not.

Horizontal rolls with larger diameters determine the shape of the section steel, and a pair of rolls with smaller diameters are used for rolling edges. Good surface finish and dimensional tolerance can be obtained when the blank passes through the conventional stand and universal stand finish rolls.